Legend of Zelda BOTW/TOTK Royal Claymore
Description
BLADE SEGMENT 4 WAS FOUND TO CAUSE ISSUES ON CURA BASED SLICERS, UPDATED AND FIXED PART UPLOADED ON 4/5/2024. IF YOU USE CURA BASED SLICERS PLEASE RE-DOWNLOAD SEGMENT 4. PURSA/BAMBU BASED SLICERS ARE UNAFFECTED Royal Claymore from the switch line of Zelda games. To print this you will need the following items -72" long 3/4" thick wooden dowel -36" long 5/16" thick wooden dowel -saw to cut dowels to length -two part epoxy to glue all parts to dowels, i use JBweld plastic bonder -strong fast curing glue for hilt, i use krazy glue after sanding the two attaching surfaces. for printing i would suggest printing the 3 grip parts and pommel with a high infill (20% or more) and for the hilt and blade a low infill (10% is what i used) for most parts minus the pommel i used tree supports and pommel was normal supports. the blade tip(segment 6) and grip bottom i did not use supports, if you do make sure you block supports from the inner support holes or have fun trying to get them out. as for blade segment 1 left and right you will need supports but make sure you use a support blocker for the 5/16 support holes this required 1.8kg of fillament and took 20 hours of printing on two printers at 180mm/s overall speeds. anything else ask in the comments and i'll try to answer or will add here.
Statistics
Likes
227
Downloads
658