Direct extrusion or Bowden tube TEVO NEREUS Complete Carriage Mount V 4.0
Description
This Carriage Mount was developed and airflow optimized to mount the mosquito hotend clones on the TEVO Nereus printer. The design allows assembly using Tevo Nereus' traditional Bowden pattern, or direct extrusion through the LERDGE Direct Drive Extruder. Use V3 parts for this HotEnd Version: https://pt.aliexpress.com/item/1005006172661180.html (especially the E3D versions). Use V4 parts for this HotEnd Version: https://pt.aliexpress.com/item/1005005355951074.html For direct extrusion use LERDGE Direct Drive Extruder: https://pt.aliexpress.com/item/1005005335847382.html This is version 4.0 has an optimized airflow compared to version 3.0. It was developed for the use of 10mm or 20mm hotend cooling fans, allowing use with higher temperatures. It also includes compatibility with new versions of the Mosquito clone and the possibility of installing direct extrusion on the tevo Nereus. It comes with versions that allow the installation of both hotend models, installation with direct extrusion or using the original Bowden tube system and also allows the installation of BLtouch. Carefully observe the assembly instructions. It should preferably be printed in ABS w/ supports, in the orientations shown in the figure.
Statistics
Likes
0
Downloads
0