3D printed laboratory power supply based on the ZK-4KX buck boost converter
Description
This is a 3D printed 20V and 1A laboratory power supply. I made it because i needed a very lightweight and portable power supply and maybe you need one too. It is special because it is 3D printed and uses a SMPS instead of an iron core transformer, which makes it weigh only 0.3 kilograms. PRODUCT PARAMETERS: Maximum allowed output voltage: 20V Maximum allowed output current: 1A Size in mm: 92x81x67 You can use it with higher voltages and currents if you have a power supply that is strong enough. This power supply is based on the ZK-4KX power supply module. In its current configuration the power supply can supply 20V and 1A, even though the ZK-4KX module itself could deliver higher voltages and currents. I have set the current and voltage limits to 20V/1A and tested the unit with these settings, do not change the limits to higher values than that!
Statistics
Likes
0
Downloads
1