Simple GPU Holder for Multiboard with Tight Snap
Description
A simple GPU Holder to put them on your multiboard, either for decorative purpose or to have it handy. **/!\ Tested so far with a Dual Slot GPU of 1Kg with dimension: 40.01 x 24.99 x 5.99 cm /!\** **/!\ It should work with Tri Slot, heavier GPU but be SURE to test before /!\** For printing, print **on the side** to get more strength (so the layers are vertical when the piece is fixed in place). I used 25 % infill, 3 walls. You can use your slicer to cut it if your GPU is smaller.
Statistics
Likes
0
Downloads
0