Joy-Con (Pro version) Case
Description
This is my first project. In this case, I have created a version for the Nintendo Switch Pro version joy-cons (or as I call them "big controllers") since I have not seen anything related. The measurements are very fair (it has currently been printed with an Ender 3 V2 Neo and a 0.4 mm noozle at a speed of 80mm/s, 60ºC bed and 200ºC noozle) and although it has not turned out bad, I have had to reduce the attachment areas a little since The PLA has been deformed by the heat (a few millimeters but enough). Otherwise it is functional, two controls fit perfectly with the straps. I will continue working on it. The measures of this proyect are: JoyConCaseBase: - High: 52 mm - Length: 134 mm - Width: 60 mm JoyConCaseTop: -High: 92 mm - Length: 134 mm - Width: 60 mm
Statistics
Likes
0
Downloads
0