Extremely inexpensive stringing test
Description
This is a very simple, inexpensive, and fast-to-print stringing test. It takes 3-4 minutes to print with a printing speed of 70 mm/s and a travel speed of 175 mm/s. The gab is about 3 cm wide. As a bonus, here are my retraction settings in PrusaSlicer for my Anycubic Kobra 2 with ESUN PLA+: Printing temperature 207 C° Use ramping lift yes Maximum ramping lift 0.9 mm Ramping slope angle 1° Retraction length 2.5 mm Retraction Speed 65 mm/s Retract on layer change yes Wipe while retracting yes Retract amount before wipe 70% I found out that at the end the "Ramping slope angle" helped with stringing the most (try to keep it low), besides the nozzle temperature of course.
Statistics
Likes
0
Downloads
0