Waveshare 8 inch HDMI LCD Hanging Mount
Description
I remixed czipis's stand to hang a [Waveshare 8inch Capacitive Touch Display, 1280×800, HDMI Interface](https://www.waveshare.com/8dp-caplcd.htm) from my monitor. Uses nothing else that wasn't included in the package except for command strips for the hanger Print includes a left and right arm bracket and a dovetail mount for each one to slide into. You should print the arms on the Y-Axis, with the dovetail mount sticking in the air with supports, they should pull off pretty cleanly since there's a fairly big gap. I drilled out the actual screw holes with a 3/32" bit pilot before screwing in the standoffs, but if you use the original screws and some elbow grease you can tap the holes pretty easily. I included two angles for the arms in the files, I'm using the shallower (30°) one on my monitor. Doesn't provide a good place (yet) for the controller buttons. Am planning on making a separate enclosure later compatible with the hanging arms (installed on the other end of the standoffs), if I ever get a chance!
Statistics
Likes
0
Downloads
0