Yarn Winder (Remixed)
Description
It is a remix of the Printable Wool Winder by matthewlaberge. Found here: https://www.thingiverse.com/thing:13816 I changed some hole sizes to allow for fewer sized hardware needed. You will need: Qty: 6 - 608 Bearings Qty: 2 - 6x13x5mm Bearings Qty: 2 - M8 threaded rod. (Determine length based on how thick your base is.) Qty: 1 - M8 x 55mm Machine Screw Qty: 4 - M8 Hex Nut Qty: 2 - M8 Nyloc Hex Nut Qty: 5 - M8 Flat Washer Qty: 3 - M6 x 40mm Machine Screw Qty: 3 - M6 Lock Nut Qty: 2 - M6 Flat Washer Qty: 4 - Rubber Bands I bought my 608 Bearings at a skateboard shop. I purchased the Cheapshots which were $13 for 8. I bought my 6x13x5mm Bearings at the RC/Miniature hobby store. All hardware was purchased at a small local hardware store. The rubber bands I used are from Dollar General. I twisted three rubber bands to use as the bumper to cause friction between the Drive Cone and the Spindle Base. The forth rubber band I used between the driver and driven pullies.
Statistics
Likes
0
Downloads
0