Replacement for Briggs & Stratton part #7011938SM snow blower chute guide
Description
Warning that I am new to modeling, if anyone has any tips to improve this model please share! Made this as a replacement part for someone else's snowblower, part is based off a Briggs & Stratton 7011938SM. We ended up having a pretty mild winter and I'm not sure if they ended up using them yet, so I don't have a whole lot of feedback about fitment, wear, or general design. Modeled in Blender and sliced in Cura, Cura says it's not watertight but it slices and prints fine. I printed with 4 walls on the tops and sides for a bit more thickness as this is a wear part, and used very little infill as once it wears through the walls it's time to replace it anyway. Intend on printing this in nylon and will update with successful settings.
Statistics
Likes
0
Downloads
0