Umarex Glock-19 CO2 4.5mm BB Airgun Suppressor
Description
This is a variation on **Gassn3r's Umarex Glock-17 airgun suppressor**. I had to shorten the Weaver rail slide because the rail on the Umarex Glock-19 is shorter. Also, the notch in the rail is closer to the front of the pistol and the vertical distance between the barrel and the rail is different, so this will **definitely not work** on the G17. In addition, I extended the *barrel* at both ends of the suppressor - it protrudes slightly at the front, and it is long enough to insert into the faux barrel in the pistol. The lengthened *barrel* provides a better seal and traps more of the gases in the baffles. I don't have a proper volume meter but using a volume app on my cell I got a roughly 10 dB reduction in the report. My printer isn't dialed in perfectly and that resulted in some stringing. So after cleaning up the print I took a series of drill bits and just inserted them by hand (from front and back), gave them a couple spins and successfully cleared up the stringing. **CAUTION:** If your printer's vertical axis is out even slightly, the suppressor won't necessarily line up properly with the barrel. Make sure you're using approved PPE when and if you use the suppressor.
Statistics
Likes
0
Downloads
2