Raspberry Pi Pico Rain Gauge
Description
All of the 3D printable parts for the ExplainingComputers "Raspberry Pi Pico Rain Gauge" project, as featured in a video of the same name uploading on June 2nd 2024. Note that the project requires either two side brackets and two clear plastic sides, or the housing with sides. Other required parts are a base board of some kind (I used a 3mm plastic sheet), a reed switch (3mm or 2.5mm cross section, c.14mm long) and magnet, six M3 nuts and six M3 bolts (the length depends on the thickness of your base board), and a Raspberry Pi Pico or similar microcontroller. All relevant code and build instructions will be available via the description for the video and on ExplainingComputers.com.
Statistics
Likes
0
Downloads
0