Arduino Mega 2560 r3 bracket for Extrusions I-Type 5 slot - Horizontal version
Description
While Building The Aweseom Http://Www.Thingiverse.Com/Thing:811271 I Needed A Way To Attach My Arduino Mega 2560 R3 + Ramps, But No Good Bracket Presented Itself For Some Reason. The Ones I Could Find Had Holes That Didn'T Line Up And/Or Were Overly Complicated. My Sourceprinter Also Couldn'T Print It In One Piece So I'Ve Split It In Two And Joined The Pieces With A Simple M3 8Mm Flat-Headed Screw And A Single M3 Nut. The 1-Piece Model Without Center-Bracers Is Available Here Too. Update 1. September 2015: Fixed Some Minor Error. Added A Vertical Version Of This Over At: Http://Www.Thingiverse.Com/Thing:993526
Statistics
Likes
103
Downloads
0