Elegoo Phecda Laser: Printable Enclosure
Description
This "enclosure" is designed to nest on top of the Phecda laser engraver machine. Leaving the underside of the machine, with the legs, open to the room. Intended for a 4" duct fan to attach to the top (not designed or uploaded yet), to exhaust particulates and smoke, blasted off the work piece by the laser head. Requires one thin sheet of PET plastic, 16" x 20", cut into four, 4" x 20" pieces. The sheet plastic inserts into the two slots on the corner objects. One larger sheet of plastic goes over the top, and bolts in, with M3 screws into two brass inserts, in each corner. Then the plastic sheets edges are taped, at the seams, with Gorilla/packing tape. I may decide to design 3D printable objects, to go between the plastic sheet edges.
Statistics
Likes
0
Downloads
0