Mr.Nibblies
Description
- Insert-able length is 155mm (6.1"), Shaft Diameter 40mm (1.6"), it also has a suction cup - mold volume: 290 mL ( 10.2 fluid oz) - Each has a mold and the actual pecker itself depending on how you are going to mold them. - mold has location for 4 10mm dowels. - can be scaled, cut and glued together to any size you want - Use Platinum Cure Silicone, Shore Hardness 10 = firm, 5 = Medium (ish), 3 = soft. - Smooth-On is a good source: "Dragon Skin 10" for firm, "Ecoflex-00-50" for medium and "Ecoflex 00-30" for soft ___________________________________________________________________ - for a quick and dirty toy (will have flashing that needs to be cleaned up) you can use the 3d printed molds - You could also sand and clear coat the mold halves, wrapping the entire mold in electrical tape to seal it - Print with thick walls ex: 4 layers or more with 8% infill ________________________________________________________________ - you can also just print the dick it self, sand it smooth, seal and make a mold the old fashion way, use this way for the best results. ______________________________________________________________ - I recommend printing vertical if possible to get the resolution. - pour the silicone to just bellow the surface then right at the end of the pot life smush the top on - a good resource for silicone toy making: https://vimeo.com/candiru
Statistics
Likes
0
Downloads
0