Motion-activated LED wand variant
Description
This is a variant of robertferanec's magic wand, tweaked to better suit the internals from Patrick_Mahoney's build, which he [details in this doc](https://docs.google.com/document/d/14bZ-IpqVbZkPPZfCg1i2cHG-t4NB6BFCnUCOYWv-gT0). I liked the look and threaded construction of Robert's design but intended to build multiple wands for younger kids, so I wanted to keep the circuitry very simple and Patrick's instructions fit the bill. The specific changes made to the STLs are: - Handle modified to comfortably fit 2 AAA batteries with a spot for a [spring contact plate](https://www.amazon.com/dp/B09XHHKDMZ) to be glued in at the top. - Bottom modified to flatten the base (for easier printing) and remove the hole for the switch. Threading is unchanged so you could easily swap back in Robert's original - Top and tip merged into a single piece, which fit the [LEDs](https://www.amazon.com/dp/B08ZY5L6S3) and wire I was working with better. I left the middle section unchanged, even though I had no specific use of the cutouts inside it. Thanks to the original two creators for providing the pieces for such a fun project!
Statistics
Likes
1
Downloads
0