Viking Tackle Pod(Twin) Transducer Adapter
Description
I take no ownership of creating these models. All credit goes toward the original designer https://www.thingiverse.com/sbursik (https://www.thingiverse.com/thing:2845134) and on his page he has the tackle pod kit which includes 4 models: 2 scupper adapters, cable cover, and transducer wire cover lid. Printed in PETG on CR-10s Pro. File TrndcrMntTop2.gcode is a snugger fit and is different from file TrndcrMntTop.stl that is slightly smaller but will still fit regardless. G-codes are also there if desired. STL file TrndcrMntBottom3.stl is the bottom part which holds the transducer and the other file is the top where all the wires go that are attached to the transducer. Refer to the original creators page for instructions on assembly via links provided in description. I forget the bolt sizes it uses but should be a 5mm bolt/screw with nut to hold transducer on mount. To hold the two pieces together should be a 9/16" or 3/8" bolt with nut and washer. This modified version is meant to leave a little space so it's not directly against the water intake for bilge pump on the Twin-Tackle Pod. This modified version should also fit on the standard Tackle Pod. Bottom part as a spot for nut to fit into so it doesn't fee spin when putting the bolt in. That said it might be a little hard to assemble from the tight space. If the head of the bolt is on the bottom with the thread facing upward in the mount you should have an easier time. Bolt and washer through hole in bottom part then attach transducer
Statistics
Likes
0
Downloads
0