Nintendo Arcade Button Bracket
Description
This is a 3D model replacement for a Nintendo arcade button bracket. It’s not 1-1 as I thickened it up from the original one I had. (1-1.5mm/0.04-0.06” metal to 3mm/0.12” plastic) Mainly wanted to make this as these are around $6-8 each brand new, and for the one cabinet I am restoring that would be almost $50 for just the one side. I haven’t done any field testing with it yet, but I have installed the button and microswitch and they fit perfectly and I intend to install it on my Jr cabinet for further testing. This button bracket should work with all Nintendo cabinets, this includes. Donkey Kong Donkey Kong Jr Donkey Kong 3 Popeye Mario Bros. R-Type Nintendo Vs. Systems Playchoice 10 Punch-Out (Start Buttons Only) Super Punch-Out (Start Buttons Only) Arm Wrestling This could also be used on other machines if desired. The holes are smaller than the screws a little bit, so you likely will not need nuts or the original screw plate, however if you find the need for it, you will need longer screws than the original. Potential future modifications: Slight indent in holes for nuts to fit in. 3D printable screw plate Long screw hole fixed
Statistics
Likes
0
Downloads
0