TFT35-V3.0 for Ghost 4S & 5
Description
Display case. Attaches to standard locations without the need to drill or cut the printer body. I tested it on Ghost 4S, but It should also work on Ghost 5, because the screen on these printers has not changed. And you can use wifi, I checked with the board ESP-01S. The inner part is a little tight to fit on standard fasteners. To attach the insert and board to the display case, you will need 4 M3 countersunk screws. Length 15-16mm To tighten the inner part with the insert, you will need 4 M6 bolts with a 10mm socket head and 4 M6 nuts. Bolt length - from 30mm. Bolts that are too long will prevent the bottom cover of the printer from closing. To attach the inner part to the printer body, you will need default display mounting bolts.
Statistics
Likes
0
Downloads
0