Stump Planter Pot Models
Description
I put a few models found here to make a variety of version remixes. Drains in the bottom to grow moss. I change the sizes depending on the plant. The largest print is about 6 inches tall and 8 inch wide. Took 8 hours to print. Smaller sizes take about 4 hours. I Added water drain ring that ties all the drain tubes together in V3 (included) that should evenly water moss or sprouts in the bowl during watering. Also included a tinkering model without mushrooms and added dimples at the end of the drain tubes. Just an Idea that printed well.
Statistics
Likes
0
Downloads
0