Filament Stand Rod Holders
Description
I found a 1.75 cm diameter pipe from an old clothes hanging rack in my basement. Rather than throw it away, I decided to repurpose it to create a filament stand specifically for my smaller spools of filament. You can print it with no supports, however it messes up around half the time. What I did was adjust my ender 3 v3 se to about default print speed as it started the ring section. It worked like a charm. 10% infill should work fine with some tougher types of PLA but I upped the infill to about 20-35. You will also have to make a copy of the original model but that's easy enough to do. You could also just print two separately. I created this in Blender. Follow to stay updated on my journey through CAD.
Statistics
Likes
1
Downloads
0