Anime Alpha Hydranoid - Bakugan
Description
Anime Accurate Alpha Hydranoid - Fully Functional For the center sliding mechanism and head, The center sliding piece uses pins as railing to smoothly slide forward and back, the length required is 22mm. Some of my early testers used a Cosmic Ingram's wing pins, but pins that fit the length requirement will do fine. I used a Base Tigrerra (B1 is what I used). The spring wraps around the pin on the Left Body (see image of the inside above) to keep the spring in place. The sliding mechanism requires a compression spring and a Tigrerra has this as well as the top flap spring can be used for the head. The wing springs and magnet springs can come from anywhere as long as they fit. Do note that the magnet spring **may** need to be cut down if tension is too high and magnet isn't activating. Pin holes are set to 1.6mm size. If you want to use your own set of pins, I recommend 1.4/1.5mm to give some clearance to rotate. Obviously, if you have a bunch of broken gans lying around and/or have access to a variety of spring and pins, freestyle it. Good Luck! **NOTE: This is a very difficult print.** I don't know a single gan that can substitute as a *sacrifice* so to speak because of it's unique parts lists (let me know if there is a single gan that is cheap and common and I will add it to to here). Don't let this deter you though, it is a very cool gan and the center sliding piece is a small but accurate to the anime.
Statistics
Likes
0
Downloads
0