Zombie control Collar V2.0 (OLD)

Description

V6.0 Is Here! Check It Out In My Other Prints. I Will Leave V2.0 Published Since Almost None F The Parts Are Compatible With The New, Improved Version, Also This One Is Currently A Bit Bigger. Note This Is An Old Version! I Made A Version Of This Collar A Few Years Ago Before I Got My 3D Printer. I Wanted To See What A 3D Version Would Look Like When Printed. Updated 10/17/15 If You Make One Of These Feel Free To Add Your Input On Printability And Design. Note This Is An Old Version! Added Battery Screw For Reference. It Is Hard To Print, You Can Order The Real Deal From Mcmaster Carr. The Battery Compartment Has Been Designed To Accommodate A 123A Lithium Battery. It Lasts Many Hours, And Is Readily Available. The Battery Door And Battery Compartment Have Holes In Them So You Can Use A Needle Or A Pin As A Hinge Pin. I Used Ide Ribbon Cable Wires For The Leds. I Have Included A Wiring Diagram For The Leds, The Resistors Can Go On Either Side Of The Led, And There Are Many Places To Put Them In The Model. The Parts Include Conduits For The Wire. To Power The Led On The Side That Does Not Have A Battery Compartment, Pass A Wire Through The Conduit Just Under The Hinge. K&J Magnetics 12.6Mmx5Mm Disks From N35 Zd3 Amazingly Strong Given Their Size. (4 Required) Digikey Supplied The Resistors And Battery Components Cf14Jt10K0Ct-Nd 8.3 Ohm 1/4W Resistor (2 Required) 36-5223-Nd Contact Batt W/Tabs Positve A/Aa (1 Required) 36-5201-Nd Contact Batt W/Tab Neg Sprg A/Aa (1 Required) Superbrightleds.Com Rl5-R3545 2.6V 50Ma Clear Red Leds. (2 Required) Mc Master Carr Part Number 91390A183 Set Screw (1 Required) Conduit From An Led Snake Light I Found On Amazon Https://Www.Amazon.Com/Dp/B003Ssaez2/Ref=Cm_Sw_Su_Dp Red "Lights" Acrylic Round Rod, Translucent Red, 1/2" Diameter, 2' Length Https://Www.Amazon.Com/Acrylic-Round-Translucent-Diameter-Length/Dp/B00Evbtq18/Ref=Sr_1_1?Ie=Utf8&Qid=1476491970&Sr=8-1&Keywords=Acrylic++Rod+Red The Battery Compartment Is In Two Parts, An Upper, And A Lowerthis Way It Can Be Printed Without Supports. You May Notice That The Chain Anchor Is Missing From This Design. I Did Not Print Mine On The Printer, Instead I Took A Pice Of Flat Bar Steel And Glued (Welded Actually) A Half A Link Of Chain To It. The Sides Of The Collar Have Places To Put Magnets In To Hold The Chain Anchor On. This Way If Anyone Pulls Too Hard On The Chain It Pops Off, Protecting You And The Prop! I Got Plastic Chain At Lowes, And Painted It Silver. Please Note, This Is Not A Screen Accurate Model, Some Liberties Were Taken, And Parts Were Modified To Simplify Construction, And Printing. The Parts In This Model An Be Printed With Minimal/No Supports. I Included Some Star Shaped Mouse Ears To Aid With Bed Adhesion When Printing With Abs. They Should Be Removed As A Part Of The Finishing Process

Statistics

Category

Tags