PetsFang v2 Max Neo Remix (Dual 5015 Fans)
Description
Remixed the PetsFang v2 to fit the Ender 3 max neo. It is not the prettiest thing, but it works. I used the Ender 2 v2 baseplate, and modified it to fit the Neo's factory hotend. Then had to modify the Fangs mounting points to fit the Baseplate. I did not change anything with the actual fan ducts. This is modified to fit the Sprite SE extruder. Had to lose the wire guide mounts in the back. I used the PetsFang ALL_BLT_LEFT_x-48_Y-10_3.29 for the CR touch mount. I cut the middle section out to fit the connector/wires. I bolted only the Left side of the CR touch to the mount. It is a bit bulky and you lose the first 7mm of the bedplate Y axis because of CR touch. I am too lazy to make it work as a right mount CR touch as I dont ever use the full bedplate. I also included the blender (V4.0.2) file in case anyone wants to make further improvements. Offsets are X:-62 Y:-13 X- stepper motor End stop position is 7.0. Min position is 7.0 max position is 312
Statistics
Likes
0
Downloads
0