Cable Clamp
Description
The base for this was taken from https://www.thingiverse.com/thing:330151 "Bag Clip - PLA compatible" by MasterFX. If you want the base of the clip, go there. There are 3 versions I uploaded. A very basic, no mounting 85mm length and 2 mountable 65mm length. The hole sized are roughly 5mm, 4.5mm and 3mm. The holes are specifically sized for my needs but in my case the 5mm snugly fits a Cat6 patch cable, 4.5mm fits a thin HDMI cable and the 3mm fits a small audio cable. Aside from the clip itself, all the edits were made in TinkerCad so its fairly simple. The V4 would use about 11g of filament on normal settings according to Cura. No adhesion or supports. I printed this using the Dremel slicer on high speed, 0.34mm and it printed just fine. The hinge pin needs to be worked just a little bit by opening and closing it a few times. Since this is based on a non-commercial design, this also follows the non-commercial license.
Statistics
Likes
0
Downloads
0