Salt Lamp switch
Description
I used the remixer to make a knob to replace a lost/broken one from my girlfriends Salt Lamp. I then took it into Tinkercad to give it some bevels so it wouldn't catch on anything and get pulled off. Honestly I probably would have been better off making it from scratch but I wouldn't have known that if I didn't break the customizer for 4 different knobs. There is a little bit of a gap where it could be wider, but the customizer width was giving me issues and so I just let it be slightly smaller instead; pictured. PLA printed though its not the best oh well it works.
Statistics
Likes
0
Downloads
0