Ender 3 S1 Riser Leg
Description
Some basic riser legs I found some time ago and haven't seen since. Don't remember who created them, but they are fairly basic. Know they fit the pads on the bottom of the Ender 3 S1 nicely. Raising the printer off the table. Block and slip on are nice, but preferred the pad sit in the block to hold it in place. The factory pads giving it the bounce it needs. Even created a high leg to bring the printer up above the lip of a case it was in. Must say, in my case, did several things to stabilize the printer but one that was a noticeable improvement was the addition of the high legs. Less calibrating and more printing are always a good thing.
Statistics
Likes
0
Downloads
0