Rc sailboat Footy. The "EZ-PZ" !
Description
WORK IN PROGRESS. This is a model of a footy boat hull that I designed. Not yet printed but I will update soon! The idea was to produce a hull that would contain a trunk for the rudder, feen and mast and that would be easy to print and without the need for supports. The boat hull is printed in half, then aligned and glued using epoxy spread over the two bulkheads. I also made a hatch the that will be cut with hot knife afterwards for the electronics. The hatch cover will be uploaded soon. Printing: The hulls shell thickness is 0.5mm (except the trunks and bulkheads inside) Therefore you need to make sure the layer line width is 0.5 Feel free to sand me any question or advice!
Statistics
Likes
0
Downloads
3