Sabot 120 mm
Description
I have designed a 1:1 replica of the 120 mm SABOT, which has a height of approximately 1018 mm. A detailed PDF with dimensions is attached for your reference. To assemble, you will need to glue the pieces together. You might also need a rubber band for the top of the SABOT to hold the pieces in place. Although I haven't tested the SABOT and penetrator yet, the tolerances should ensure a proper fit. Some pieces have been given additional tolerance to improve the fit. In the worst-case scenario, minor sanding might be required. It may not be accurate 100% this piece, because some pieces had been optimized for better print orientation requiring less support or sanding. It can fit in an Ender 3 v2 I hope you like it! :D
Statistics
Likes
0
Downloads
0