DT3 USB Cable Tester Case
Description
This is a case for a DT3 USB Cable Tester board. It is available in monochrome and coloured versions. You will need to assemble it using some CA glue. You'll have to glue the light conduits to the inside top cover, aligning the 5 holes. Use the alignment tool to assemble the light conduits. Be careful no to glue is. Glue is required only in the centre of the conduits. Support material is not required. An infill of 20% is recommended. This object main web page is: www.ctheroux.com/dt3-usb-cable-tester-case/. This object was designed using Solid Edge Community Edition. You can request the source files on the page listed above.
Statistics
Likes
0
Downloads
0