Sinden Lightgun G1/2 Shower Hose Adapter
Description
This is my G1/2 Shower Hose Adapter for the Sinden Lightguns. It enables you to add a metal shower hose with a G1/2 fitting for your cables as a sheath. <h2>Instructions:</h2> 1. Open up the Lightgun and remove the USB cable 2. Close it back up again and drill out the hole where the cable runs along (should be 16mm) 3. Insert the Cable through the adapter 4. Put in the adapter (there might be some internal struts that have to be removed/filed down. I decided that removing a bit material from the inside of the gun is structurally better than having a weakpoint in the print) 5. Install USB wire 6. Close up the gun
Statistics
Likes
0
Downloads
4