Samsung S21 FE cover
Description
You are very welcome to experiment with the first layer pattern. ‘Octagram spiral’ and ‘Hilbert curve’ are my favourites for this purpose. <B> Printer settings: </B> <ol> <li>Filament: I recommend using PETG, ABS, PLA. Avoid Flexes as they will be very loose. </li> <li>Layer: 0.2mm - this is crucial.</li> <li>Infill: no</li> <li>Walls: 3 walls, 3 bottom</li> <li>Supports/rafts: not required.</li> </ol> <B>Following changes are done:</B> <ol> <li>Back wall was increased from 0.92mm to 1mm in order to match camera modules ‘hill’ and adopt model to 0.2mm layer print.</li> <li>Added a cutout for magnet phone holder plate.</li> <li>Buttons cutout was completely changed.</li> <li>Top and bottom cutouts were increased as the origin model had been cracking and didn't fit (PETG).</li> <li>Display border edge was quite sharp and too high that had been making side swipes almost unusable. Now it is less high (-0.2mm) and more blunt. </li> </ol> Tips for designers are always welcome: https://www.buymeacoffee.com/Serhiok
Statistics
Likes
0
Downloads
0