Kobra 2 Neo LCD Screen Cover and Button
Description
Kobra 2 Neo LCD Screen Cover and Button this is my cover for the Anycubic Kobra 2 Neo since i like white and the printer comes in a horrible bluish and red colors the way i printed the cover was by splitting the cover into 2 halves in Prusa slicer then gluing with superglue, i used pin connectors at 1.5 mm to make it align perfectly i split or cut the body from the lowest section of the front plate so when i printed the parts i had the front plate with a smooth surface from below because it was at the print bed, and the other half was the walls, this way i avoided using supports since the last time i printed with supports it was really bad and the LCD and the chip did not fit perfectly there is also one thing there one of the chip supports on the side walls that is at least 0.25 mm short causing the LCD to mounted at an angle so i just jammed a piece of paper in between and it works flawlessly and there is no need for a back plate, just jam that thing in (you can see the pictures i took) and it should hold perfectly i used Anycubic PLA at 210C for nozzle, 60C for bed 0.1 layer height and a 0.4 nozzle, 0.2 first layer, and ironing was on for the Button just print it face up no supports no nothing needed the Print time for the cover took me 2 hours and 22 minutes, the Button was 25 Minutes and i also sliced from STEP files not STL makes things much cleaner and smoother
Statistics
Likes
0
Downloads
0