Kyosho Triumph Front Knuckle / Spindle
Description
Front knuckle/spindle for the Kyosho Triumph buggy. Tap the mounting screw with a M2.6 tap. Ream the pivot with a 4 mm drill bit. Carefully bore the axle hole with a 7 mm drill bit. NOTE: I have not yet printed to confirm dimensions but this should be very close. I expect that I may need to tweak the hole sizing for the M2.6 hole. As always, an original part or a Shapeways produced part in nylon/ABS is going to be best for this type of part. I may update this design to change to a M3 screw hole for the turnbuckle as the M2.6 screws on the older Kyosho buggies can be difficult to find.
Statistics
Likes
0
Downloads
0