Elgato Ring Light Monitor Arm Mount
Description
The Elgato Ring Light comes with it's own desk clamp and stand but with my existing monitor arms I had to mount it off centre and a little further back than I liked. I design this cap to slide over top of the centre pole on my monitor arms and then you can re-use the pivoting clamp and mount that goes on top of the provided Elgato mount. I printed at 100% infill and am hoping this will end up being strong enough. The diameter of my monitor arms centre pole is 32.4mm. If that size doesn't work for you I suspect you can easily import this into TinkerCAD, lop off the bottom cylinder, add your own for your specific diameter and you're off to the races.
Statistics
Likes
0
Downloads
0