InMoov Omoplate Servo Holder for small servos (20*40*44 mm)

Description

This Is A Replacement For Inmoov Part Servoholsterv1 (Shoulder) To Allow The Small Turnigy Tgy-Mg959 Servo (20X40X44 Mm, Hobbyking) To Drive The Omoplate. It Maintains The Same Geometry As The Original Hs805Bb Servo (29X65X68 Mm). View Performance Here Https://Www.Youtube.Com/Watch?V=0Mpalebhf94 Changing The Servo Into Continuous Mode Is Rather Easy - Removing The Screws Is Easy And Everything Comes Apart (Use A Knive To Separate The Different Parts). Remove The Bolt And Poti. Attention: The Turnigy Turns Anti-Clock - You Need To Switch The Motor Cables Too When Taking The The Poti Out (Both Cables Are Red, Mark Them Before Switching Them) -- And Verify The Correct Red/Green Poti Cables Before Using Mrl Commands On It! Update: Added A .Scad File That Should Allow To Create Holders For Other Sized Servos. You Need To Install Openscad To Specify Your Servos Dimensions And Create The Stl

Statistics

Category

Tags