FIXED Support Pillars - 50mm to 250mm
Description
The original pillars have a gap between the hex mounting bottom piece and the body. Normal printing shouldn't have an issue because most slicers will ignore such a small gap and slice normally. But when the pillars were placed on their heads (so that the hex ring piece would be printed on top, and tree supports were used, the gap was discovered which caused the base and the body to separate after printing. I have fixed the models so they are solid bodies. I also ran the design through an online .stl fixer because there were a couple flat edges that were non-manifold on the original 200mm height. I also made a 250mm version because the Bambu Lab A1 can handle it.
Statistics
Likes
0
Downloads
0