Door Hanger Hook
Description
Not really a re-mix, but re-scaled uniformly to 80% using slic3r for a perfect fit (why isn't slic3r in the drop-down list???). Essentially, the previous door hook (a re-scaling of https://www.thingiverse.com/thing:6470702) experienced delamination because of the constant downward pull of the combined shower curtain and rail weight, so I needed something reinforced. The bottom reinforcement on this design should prevent this happening again. Also, adapting the original design was a simple matter of re-scaling it uniformly to 80% of the original's size, and this was a perfect fit not only for the 37mm bathroom door top, but also for the diameter of the rail. Minimal adaptation, but perfect, which just goes to show that if you find the right design, you don't have to spend all day fixing it. Plus, a lesson learned about the necessity of reinforcement for load-bearing prints. Also, the *.stl here is unmodified, as it was the gcode that was rendered before printing. However, the web form insisted that I had to upload a suitable file and this was the only one used. Is this a bug?
Statistics
Likes
0
Downloads
0