Fallout Vault Tec Fidget Slider
Description
The Vault-Tec logo from Fallout - in fidget slider form! - SUPERGLUE IS REQUIRED FOR THIS MODEL - Materials needed: 12 * 8x3mm neodymium magnets I used these 8x3mm magnets from amazon which are actually 8x2.75mm: https://a.co/d/hJVzD7e Instructions: - Add a small drop of superglue at the bottom of each hole. - Carefully insert a magnet into each hole and press it all the way in (Keep the magnets' polarity in mind for each half!) - Add a thin layer of superglue to the bottom of the cover and firmly press it into the fidget slider. - Repeat for the other half of the slider. - Enjoy! Please consider supporting my models over on MakerWorld: https://makerworld.com/en/@Empty_Dustpan
Statistics
Likes
0
Downloads
0