longboard runaway brakes
Description
designed to fit my $89 amazon longboard with a tail size of approximately 13 cm long and 13 cm wide, this is supposed to use 2 m4x25 bolts with nuts that slide into the 2 slots in the hinge piece on the brakemain piece. it is supposed to use some form of pin connected to one of those retractable key lanyards that you clip to the bottom of your pants so if you have to stop quickly and cannot stop your board from speeding away, it pulls the pin and engages the brake. i made the feet a separate thing because if printed in pla, if you cant figure out how to add rubber stoppers, they will wear down very fast. i have not made this yet, waiting until my 3d printer is back in commission.
Statistics
Likes
0
Downloads
0