kindle paperwhite 11 holder
Description
I had trouble finding a Kindle paperwhite 11 holder that suited my preferences, so I designed my own using Fusion360. I noticed that I prefer different shapes on either side of the Kindle because I hold it differently with each hand. The supports are only needed on the handles, where the recesses are located on the bottom. This holder is quite large and thick, it nearly gives the sensation of holding a book. The large tapered slots along the back fit my fingers perfectly. It should fit printed at 100%, as I didn’t include any tolerance in the design. Also use of the power button and charging port should not be obscured. All 3 files are the same, I prefer to use 3MF over STL, as dimensions and tolerances seem to be better, but the STL is there too.
Statistics
Likes
0
Downloads
1