Push-lock part for Ultimaker S3/S5 core
Description
I had a couple of Ultimaker S3 (S5) cores that were not usable because of the failed plastic lock part. Cores are very expensive ($165-$300) and you cannot buy just that part. Which is very annoying. So, I decided to make it. Took 1 hour of drawing and 3 hours of printing and adjusting. Here it is, works pretty good. Notes: - I did not try using cores with PLA part. I think it is not going to work. Currently I fixed my broken cores with parts printed in PETG. I will try some clear PC later. Should work too. Maybe nylon will work, but I have a feeling it is too flexible. - There is a one layer (0.2 mm) plane in the screw hole. This is done on purpose. It is easy to punch it through with a screw. But it completely eliminates the need in support.
Statistics
Likes
0
Downloads
0