Ender 3 v2 Adjustable Y endstop
Description
Adjustable endstop for Y-axis Ender 3 v2 The Design I modified is https://www.thingiverse.com/thing:3463987 The changes are as follows 1. Slightly thicker at 6mm. This was done so the stock self tappers could be reused from my ender 3 v2 they where a bit long with the thinner one. 2. Slightly thinner and shorter adjustment slider. This was done so I can use m4 or m5 T nuts with this set up since my ender 3 v2 didn't have pre drilled holes for the switch. 3. Added 1mm indent. This was done to fit the small solder pins hanging down on the front of my switch. I use this on my ender 3 v2 since the original mount broke and had no adjustment PLA should be fine for the print I would recommend PETG or ABS I went with PETG
Statistics
Likes
0
Downloads
0