GraviTrax Spin Wheel (Roundabout)
Description
Here's a spin wheel for GraviTrax. It has 4 advantages over the GraviTrax Roundabout on Thingiverse: 1. It can be printed on a flat print bed, without a gob of filament support to cut off the spinner. 2. The spinner is captive to the base so you don't lose the spinner part in the toybox. 3. The base has a built-in mounting ring that you pop out, turn 30 degrees, and glue on. 4. The base isn't floating in air when you load it in your slicer. Print with variable layer height for smooth top surface. Assembly afterwards is a tight fit. Just gently but firmly press the spinner onto the base post past the detent, then it will snap on, and the spinner will be captive to the base so you don't lose the spinner. It *may* be possible to remove a spinner using a screwdriver while pulling up evenly on both sides. But it is also possible the post will break off when trying to remove the spinner. This design remixes using a straight-through base tile, but everything else is my unique design.
Statistics
Likes
0
Downloads
0