FIXED Remix of GraviTrax 2-in-1 and 3-in-1 with 120 degree curve by DogDude3D
Description
Just found the tile version of GraviTrax basic tile insert 2-in-1 and 3-in-1 with 120 degree curve by DogDude3D and printed it out, until I noticed 3 problems. 1.Rail holes too wide to be fit with any Gravitrax rail design e.g. Ravensburger rails in your starter sets. 2.Hexagons are not the same size compared to Ravensburger tiles. They are slightly smaller than the original Gravitrax. 3.Hexagon "connectors" are NOT perfect for good compatibly. Luckily, I fixed it by using the "Gravitrax Tiles Variations Collection" by ImShogun and then used a single straight and a single 120 degree curve. I combined these parts to form these parts by using the "Combine" function and then use the "Intersect" function to create these parts. :) Note: THE HEX CONNECTOR IS NOT MISSING, IT IS INSIDE THE TILES. It does not need to be printed separately!
Statistics
Likes
0
Downloads
0