Panel Lock
Description
This lock is for a 18mm panel. If you want to use it on a 12mm panel use the parts with the "_short" extension in the name Drill 20mm hole in panel push part #1 through hole push part #2 over part #1 and glue it to panel push part #3 through put part #4 on the end of part #1 glue part #5 as a stop on part #1 Some parts might be a tight fit (especially parts #2 and #5) to have a clamping effect, so a bit of pressure should do the trick to get them in place. There's always room for improvement, so any suggestions are welcome
Statistics
Likes
0
Downloads
0