Holder for up to 6 Ryobi Batteries LINK compatible
Description
An over engineered battery holder for six One+ 18 volt batteries that can be mounted to the wall and works with link rails. The bottom three slots can fit up to 4Ah battery sizes and the top three slots can hold any size of battery. Printed at 0.28mm layer height. Tolerances of this gave a slug fit for the batteries to stay in the mount even upside down and still could be removed easily. Fits over two link rail slots or just one cleat (the middle bit). This was designed to fit between two rails above and below the the rail. Only down sides are that it takes a bit of filament and supports don't come off easily (unless tree supports are used but I don't use them since my printer sometimes fails with tree supports).
Statistics
Likes
0
Downloads
0