ARTILERY X3 EXTRUDER HGX Lite 2.0 + HOTEND BAMBU LAB
Description
Replacement head for X3 ARTILLERY printers. almost identical dimensions, no difficulty in swapping. A high-performance hotend the HGX lite 2.00, 48gr, very light ! with large drive wheels does not crush the filaments so the flow will be constant, ideal for soft filaments such as TPU. A ratio of 9.5:1 much higher than the original extruder allows very high flow rates. The small diameter, ultra-light motor has less inertia, therefore faster. The BAMBU LAB X1C type TZ compatible hotend, offering a large choice of nozzles. These components are all available from ALI... The body of the head to be printed preferably in ASA or reinforced nylon. Possible at PCWAY or other 3D workshop, in resin or FDM choice if your printer does not allow it. Possible in PETG if you limit yourself to filaments that do not require too high printing temperatures. All M3 screws, except those of the hotend fan M2.5 screws. You will have to adapt the connectors. All connectors on the PCB are ZH 1.5mm type except the heater which is a XH 2.54mm Necessary to configure printer.cfg for klipper, for Marlin you will have to recompile a firmware. With the indicated parameters.
Statistics
Likes
0
Downloads
0