X-Carve reverse drag link bracket
Description
I Remade The Bracket That The 1000Mm X-Carve Uses On The Left Side Bottom And I Am Using It On My 500Mm X-Carve. I Also Reversed It So That I Can Feed My Cables Out The Back Of The System. I Didn'T Like The Way The 500Mm X-Carve Drag Link Chains Were So I Printed Some Of My Own That Were From The 1000Mm Version. The Model Is The Standard Bracket. I Just Flipped The Model In Cura So That I Could Get A Reverse Of It So That It Was Correctly Oriented When I Put It On The Back Rail. You May Have Notice My Front And Back Rails Under The Waste Board Are A Bit Longer And Sticking Out. I Put Longer Rails In So The I Could Mount The X-Carve Easier To My Cabinet I Made.
Statistics
Likes
33
Downloads
0