Ender 3 Original/V1 Riser Feet
Description
- Remixed it specifically such that it fits with the [PSU Rear Mount](https://www.thingiverse.com/thing:6761271) on the original Ender 3. - The length has been increased and also made it flat on the sides so that it doesn't interfere with the the PSU Mount. - Made the Rubber Feet indent smaller. The one I used were from amazon and the indent is sized for them 25x25x4.5mm (You can also cut the original feet to size and glue them on, I just didn't want to apply new glue :p) - Tight fit, it won't move so that's good but just lightly spray it with water and a hit it with a rubber mallet if it doesn't go in easily.
Statistics
Likes
0
Downloads
0