Arcade Spinner Joystick - Large Buttons - Vinyl Graphics
Description
This is a remix to accommodate a spinner. I've also included some vinyl graphics for the buttons and spinner. I've only included the modified files so you will have to download the original "Retropi Arcade Stick" -> https://www.thingiverse.com/thing:2456203 I used a Arduino micro pro controller with the Joystick library. Instructions can be found here -> https://craigb-spinner.github.io/Arcade-Spinner/ The biggest problem is getting the joystick library to install in Arduino IDE. You have to extract the library and remove "-master" from the library name and then rezip it. After that it will install. I shaved off the mounts for the Pi controller since I didn't use it. Prints easier. I recommend printing the first few layers (1cm) of left and right sides with .2mm or lower as there is a lip there. Keep your fan low so you get good layer adhesion. Mine came out crappy and I sanded it and applied some black fingernail polish. This project takes a lot of filament, especially if you have to reprint something. I went through almost 3/4K spool. Make sure your printer is dialed in before starting. The vinyl graphics aren't perfect - But their free. The spinner I used can be found here -> https://www.amazon.com/dp/B07MX1SYXB?ref=ppx_yo2ov_dt_b_fed_asin_title Knob I used -> https://www.amazon.com/dp/B09C7K1BZL?ref=ppx_yo2ov_dt_b_fed_asin_title I have attached a diagram of the spinner so you can drill holes to mount it. I used the outer most holes to get the most bite.
Statistics
Likes
0
Downloads
0